How to load device firmware on the TTPRO

How to load device firmware on the TTPRO

If you are needing to update firmware on a Nice shading device use the below steps and then follow the instruction in our separate KB article.

You will need to download the attachment and unzip it. Run this on a Windows computer.

With the USB cable connected from your computer to the TTPro, open the software. 


 

Select your COM port from the drop-down menu (you may need to open Device Manager to see which Comm Port it has picked up) and then click "Open Port." 

Then click Start, and you should see the TT Pro come to life and the LEDs start blinking. 

Then go to the Search FW option, select your Firmware file, and click Download File. It will download your Firmware to the TT Pro. 

When it comes up with the finished message, you can then disconnect the USB and take your TT Pro to update the device in question. 

(This software does appear to work on a Mac running Parallels even with Apple silicon)

    • Related Articles

    • How do you update the firmware on a Nice DMBDGW

      To do this, you will need a TT Pro pre-loaded with the firmware that you need to update on the device. See the other knowledge-based article on how to load the firmware onto the TT Pro. ...

    • MXNET EV/DV2 FPGA Firmware Mismatch - How to Check & Resolve

      MXNET Firmware Update: Troubleshooting Guide Issue Overview: AVPro Edge’s latest FPGA firmware update (version 9.18.9) introduces valuable enhancements, but some users with older firmware (version 9.13.1) may experience compatibility issues, ...

    • How to recover an Araknis AP from firmware update failure

      So when you see the SSID failsafe, this means that there is an issues with the firmware. The IP address of the WAP will be 192.168.20.253. If you static your computer to 192.168.20.xxx you should be able to plug the WAP into your computer and access ...

    • UPDATING XANTECH ACM FIRMWARE TO V1.34 (latest release - 2/8/24)

      To update xantech video over IP ACM module to latest firmware - v1.34 (latest as of 2/8/24) follow the attached guide, then make sure to follow integration note for the product found in management cloud if link to fw download within the guide is not ...

    • Why do i need to use a diode on the lock connected to a 2n device?

      A protection diode is one of a few suppression devices for electronic door hardware. It is a standard semiconductor device integral to the safe and proper function of the access control system, it acts as a grounding tool, allowing the flow of ...