How to trigger the relay on an Akuvox intercom from an Akuvox Access Control Unit

How to trigger the relay on an Akuvox intercom from an Akuvox Access Control Unit



See below, this example is using an E18 (intercom) & E16 (Access Control Unit). It's the same principle for other devices.



    • Related Articles

    • How does Akuvox licensing work?

      There are 3 types of installations. Each of our Akuvox dealers need to be setup on the Akuvox ecloud. We need to do that for them and they then get a login, Once logged in they can create 3 types of customer sites. Single Family SIte Community ...
    • Akuvox X912 Not Registering in Control4

      Assuming that the firmware is fully up-to-date (912.30.11.61 as of time of writing), if an X912 still won't pull correctly into Control 4, it may be that the intercom hasn't automatically enabled itself for Control 4 operation The following "hidden" ...
    • INTEGRATING ELAN GATE CONTROL WITH APPLE HOME (SIRI VOICE CONTROL)

      OVERVIEW This guide explains how to control a gate connected to an ELAN controller using Siri via Apple Home. The solution uses: - ELAN String-to-Event driver - Homebridge running on Raspberry Pi - homebridge-garagedoor-command plugin - TCP string ...
    • Troubleshooting Tips For Access Control Reader

      Wiring is one of the biggest causes for problems when using the 75A00-2 Access Card Reader. The pinout for the built-in serial ports on Leviton controllers are: With the above stated, your pinout should be using Pins 4 & 5, where Pin 5 should be ...
    • TPLink PoE Recovery function and issues it may cause

      TPLink have a feature in some switches called PoE recovery Info on this feature is light, but in our opinion it appears to monitor the data stream to a connected device and if it senses a loss of data traffic it will reboot the port, which is fine ...