New scenes not being controlled in Control4 with Engineering Solution DMX controller
Problematic setup is Control4 using the the Engineering Solutions DMX controller (either older SKU-11X models or the new 119-DE4)
The reported issue was "the whole system works fine triggering individual fixtures and around 30 scenes already working via advance lighting scenes. when creating a new scene we can add in the colour levels etc even pull in current colour & levels but once saved it will not trigger or even toggle off. Some rooms work fine others don’t allow any scenes to work at all."
this was identified as being a driver or Control4 issue and on further investigation with the driver developer they found the bug, agreed with our assessment and issued instructions for the fix (below)
"Use the Delete Scene Database action on the RS-232 DMX Engine driver
Open a scene where there is DMX load in it, and select “Sync All Scenes” in the top corner"
Related Articles
IR within AVProEdge solutions
We often are asked about the specification and setup of IR within AVProEdge solutions The IR output voltage for AVPro products is standardized at 5 volts - so IR emitters that are connected should be 5V IR Receivers (an IR Eye) should also be 5V as ...
Troubleshooting Tips For Access Control Reader
Wiring is one of the biggest causes for problems when using the 75A00-2 Access Card Reader. The pinout for the built-in serial ports on Leviton controllers are: With the above stated, your pinout should be using Pins 4 & 5, where Pin 5 should be ...
How To: Using the MXNet USB Control Tool
Powerpoint and software for the USB Control Tool used when configuring Point To Point, Multicast Settings, and Control Routing. Extra information. To manually set the channel to 0000 via command line astparam s ch_select 0000;astparam save;sleep ...
How to enable IP Control on LG TVs
You will need the basic IR remote as the magic remote will not work. Make sure the TV is on an input with no signal such as Live TV with no aerial. Press and hold the Setting button on the remote. Wait until the banner on the left pops up letting ...
Araknis Spanning Tree
By default Spanning Tree, is enabled in Araknis 210 and 310 switches, but the Root Bridge is usually an overlooked element. Spanning Tree Protocol (STP) is a Layer 2 protocol that decides the best path for LAN traffic when multiple options exist, ...