Stream 2 audio is corrupted

If you experience this issue then set the unit to reboot the Linux server process daily at 3 am. This simply starts the single Linux process and takes seconds to execute and will solve this problem.

Run up the Ovation utility 

Go to Manage and Schedule

On the new window will appear. Now click Add.

A new window will appear.

Click Add -> Server -> Reboot

Set the time to be 3am Daily and never expire and select OK

Click Apply

This will reboot the server process once per day at 3am and will prevent this from happening.

• Related Articles

• How do I setup audio return paths in MXNet 1G V2

  A decoder can only be routed to one encoder at a time. You can't have one decoder sending an Audio Return Signal to multiple encoders, for example. A lot of sites utilize CEC for volume adjustment/control of source and sink devices, this ...

• Poor Audio Quality on 2N Verso

  The 2N units are 3 high units. When you go 3 high you need to move the microphone down to the bottom.

• Poor audio quality on intercom to a door station

  if you get poor audio quality at the door station using ELAN then try enabling QOS on the router and the switches. You do not need to configure anything, just enable it. That will priorities audio packets and improve the audio quality. 

• Video stream from external Pakedge IP camera shows intermittent network error

  If you are adding a Pakedge (Lilin?) camera to a 2N intercom or video kit using the enhanced video licence function, we have had reports that the stream connection will flick between connected and network error To resolve this go into the Network ...

• Zektor Audio Management With C4

  Control4 does not have the ability to extract audio from HDMI, their control system treats HDMI as a video only source. So to extract audio, you have to trick Control4 by using dummy bindings. Luckily they seem to know this is a problem, and have ...