What ports do I need to open for the Visualint NVR to Use Observer Remotely

What ports do I need to open for the Visualint NVR to Use Observer Remotely

The app uses port 9786

To use Observer remotely you need to open port 9780. 

See attached

    • Related Articles

    • What is the difference between Visualint and Lilin IP Cameras

      The key differences between Visualint  and Lilin would be Analytics and Starlight Technology. Analytics Visualint Intelligent cameras are equipped with a full analytical engine built into each camera. This means that there is a microprocessor in each ...

    • Adding Visualint cameras to Lilin NVR

      general adding of the camera is as per any onvif camera into the nvr,  browser and touchscreen views all work from the initial setup, but if images do not populate when pulling the hdmi output into tv, then you must set the camera connection type in ...

    • Adding a Luma NVR to OvrC

      Please be advised when adding the NVR to OvrC it is required to use the Mac address and the Serial number.   The ST number is NOT the serial number of the unit.   Please use the Luma utility or login to the unit to find the serial.   This is done for ...

    • How to set up an Araknis 310 Switch to use with AVProEdge MXNet

      We always recommend using the AVProEdge switch range when installing an MXNet system. These switches are very high end and come with a 10 year warranty and are pre configured out of the box to work with MXNet. However, if budget is a concern and you ...

    • Pull a MJPEG Stream From a Luma NVR For a Luma Camera Connected Direct to NVR

      This can be done with the following URL http://<IP address of the device>:<web port of the device>/wps-cgi/mjpg/video.cgi?camera=<number>&resolution=640x480&username=<user>&password=<password> Where IP address is the NVR and port is the port the NVR ...