Which Plaster is best suited for Cerasonar speakers?

Which Plaster is best suited for Cerasonar speakers?

All our cerasonar loudspeakers are already primed with Ardex P4. For further processing, we recommend a spatula on the basis of plaster-plastic. We have tested the following plaster:

- Ardex 828
- Ardex R1
- Ardex 820 Superfinish
- Knauf Uniflott (available in most DIY stores)

(For the US market, a premixed grout with standard drying time can be used)

Do not apply more than 2 mm of plaster. Less is more, otherwise the maximum volume is affected.

    • Related Articles

    • How to Use the DSP Presets and Calibrate Cerasonar Speakers

      See https://www.youtube.com/watch?v=xU9UxNS4RrM

    • Akuvox X912 Not Registering in Control4

      Assuming that the firmware is fully up-to-date (912.30.11.61 as of time of writing), if an X912 still won't pull correctly into Control 4, it may be that the intercom hasn't automatically enabled itself for Control 4 operation The following "hidden" ...

    • Araknis Spanning Tree

      By default Spanning Tree, is enabled in Araknis 210 and 310 switches, but the Root Bridge is usually an overlooked element.  Spanning Tree Protocol (STP) is a Layer 2 protocol that decides the best path for LAN traffic when multiple options exist, ...

    • Why do i need to use a diode on the lock connected to a 2n device?

      A protection diode is one of a few suppression devices for electronic door hardware. It is a standard semiconductor device integral to the safe and proper function of the access control system, it acts as a grounding tool, allowing the flow of ...

    • Araknis Spanning Tree CIST

      This was highlighted by a SnapOne TierII engineer, which we have summarised into the below information.  Enabling Spanning Tree protocol is fine, but you aren't telling the switch what ports need to participate in the Spanning Tree. In the STP menu ...