Reload the HR200 Config On SSD

Reload the HR200 Config On SSD

Unzip the file

Connect the HR200 and type 3526 to make USB active

Then treat it like a USB drive and format the drive using quick format

Then copy the 6 files across to the newly formatted USB drive (this can take a while as transfer is slow – 10+ mins)

Then power off the remote and connect it again to the system


When the remote comes back online and is connected to laptop it has the default HR2TEST SSID and Password so the WIFI details will need reentered but this is the correct process to load the new clean configuration onto the remote

    • Related Articles

    • DMZ Configuration

      To set up a DMZ to an Araknis router is straight forward.  If applicable, the first thing to do is set the ISP router to a range away from the range of the Araknis router. For example, if your ISP router, by default is on 192.168.1.1, you will need ...

    • INTEGRATING ELAN GATE CONTROL WITH APPLE HOME (SIRI VOICE CONTROL)

      OVERVIEW This guide explains how to control a gate connected to an ELAN controller using Siri via Apple Home. The solution uses: - ELAN String-to-Event driver - Homebridge running on Raspberry Pi - homebridge-garagedoor-command plugin - TCP string ...

    • Akuvox X912 Not Registering in Control4

      Assuming that the firmware is fully up-to-date (912.30.11.61 as of time of writing), if an X912 still won't pull correctly into Control 4, it may be that the intercom hasn't automatically enabled itself for Control 4 operation The following "hidden" ...

    • How to load device firmware on the TTPRO

      If you are needing to update firmware on a Nice shading device use the below steps and then follow the instruction in our separate KB article. You will need to download the attachment and unzip it. Run this on a Windows computer. With the USB cable ...

    • How do I setup audio return paths in MXNet 1G V2

      A decoder can only be routed to one encoder at a time. You can't have one decoder sending an Audio Return Signal to multiple encoders, for example. A lot of sites utilize CEC for volume adjustment/control of source and sink devices, this ...