Disabling Window 10 Auto-Updates

Disabling Window 10 Auto-Updates


This article describes the process for turning off the auto-updates for both the Pro and Home versions of Windows 10.

Window 10 Pro


Open Group Policy Editor and head to Computer Configuration > Administrative Templates > Windows Components > Windows Updates.



Double-click "Configure Automatic Updates".  Select "Disabled" and hit OK.





Windows 10 Home


Open Registry Edit (Windows > Run > regedit), and go to HKEY_LOCAL_MACHINE\SOFTWARE\Policies\Microsoft\Windows\WindowsUpdate\AU.



Double-click NoAutoUpdate and change the Value data to 1, and hit OK.




If there is not already a value for "NoAutoUpdate", you'll need to create it by right-clicking in the white space in the pane on the right, going to New > DWORD (32-Bit) Value and then name the newly created value "NoAutoUpdate" (without the ")



    • Related Articles

    • How to recover an Araknis AP from firmware update failure

      So when you see the SSID failsafe, this means that there is an issues with the firmware. The IP address of the WAP will be 192.168.20.253. If you static your computer to 192.168.20.xxx you should be able to plug the WAP into your computer and access ...

    • Adding a Luma NVR to OvrC

      Please be advised when adding the NVR to OvrC it is required to use the Mac address and the Serial number.   The ST number is NOT the serial number of the unit.   Please use the Luma utility or login to the unit to find the serial.   This is done for ...

    • Adding Visualint cameras to Lilin NVR

      general adding of the camera is as per any onvif camera into the nvr,  browser and touchscreen views all work from the initial setup, but if images do not populate when pulling the hdmi output into tv, then you must set the camera connection type in ...

    • Pull a MJPEG Stream From a Luma NVR For a Luma Camera Connected Direct to NVR

      This can be done with the following URL http://<IP address of the device>:<web port of the device>/wps-cgi/mjpg/video.cgi?camera=<number>&resolution=640x480&username=<user>&password=<password> Where IP address is the NVR and port is the port the NVR ...

    • Omni Phone Line Light and Click On and Off

      Telephone Access Problems Checking the Phone Line Detection when the controller can't access the voice menu: Does the console display "PHONE LINE DEAD TROUBLE NOW"? All controllers are polarity sensitive and require a minimum of 24 VDC on the ...