Factory Reset S560 via Akuvox Cloud Installer Account

• Related Articles

• Akuvox X912 Not Registering in Control4

  Assuming that the firmware is fully up-to-date (912.30.11.61 as of time of writing), if an X912 still won't pull correctly into Control 4, it may be that the intercom hasn't automatically enabled itself for Control 4 operation The following "hidden" ...

• How to trigger the relay on an Akuvox intercom from an Akuvox Access Control Unit

  See below, this example is using an E18 (intercom) & E16 (Access Control Unit). It's the same principle for other devices.

• SpeakerCraft MRA-664 Resources

  Factory Reset https://www.dropbox.com/s/afuj17rza6hlmc3/factory_reset.zip?dl=0 Latest Firmware https://www.dropbox.com/s/mf5zzgram6nbzb9/2_1_126_0.exe?dl=0

• How to setup MXNet switches to be accessible on the LAN and via Switch Management on Mentor

  The MXNet switch has an RJ45 port labelled Mgmt which is the management port. You can access the management port by connecting a patch lead to the management port and connecting the other end to your computer. By default the IP address of the ...

• Araknis/OvrC devices cant be reached via dashboard when using ISP router

  A new installation of an OvrC hub and 4x AP's on a site with latest SkyQ hub, OvrC dashboard works fine but you cant connect to Araknis devices in the device list you get the following error message the ports required to be opened are 53, 443