2N
USB KVM Not Working with MXNet 1G V2
If you are finding the USB KVM feature is not working with MXNet 1G V2 it may be because the USB mode on the encoders is different to the USB Mode on the decoders so they are not compatible. This can be fixed by doing the following. You will need to ...
Installation guide for 2N 2Wire Kit
The 2N 2Wire adapter kit is extremely useful. Giving you the capacity to use exisiting 2 wire cable runs to connect IP devices to a network and power the device via PoE. But it’s worth doing your homework so you can get the most out of them. To help ...
HDMI CEC in MXNet Mentor
In order to send an HDMI CEC command from Mentor, we need to know the values for the following; SOURCE, DESTINATION, OPCODE. Then depending on the Opcode being used, you may also need some additional parameters under the DATA field. SOURCE: This will ...
2n Automation - Start a Phone Call to My2n based upon Incoming Call
Register SIP1 to the PBX and SIP2 to My2n Create a Directory User for the My2n Mobile Devices Create Automation based upon CallStateChange > Call Answered, Where CallerID is the incoming phone number, If the phone number is dynamic and you want all ...
Why do i need to use a diode on the lock connected to a 2n device?
A protection diode is one of a few suppression devices for electronic door hardware. It is a standard semiconductor device integral to the safe and proper function of the access control system, it acts as a grounding tool, allowing the flow of ...
Accessing ATEN PDU WebGUI When An SSL Error Is Reported
It may be experienced that access to the WebGUI of an ATEN PDU such as the PE6108G or the PE8216G is restricted due to an SSL security error. The reason for this is that the PDUs on earlier firmwares use TLS 1.0 whereas many browsers have now been ...
Video stream from external Pakedge IP camera shows intermittent network error
If you are adding a Pakedge (Lilin?) camera to a 2N intercom or video kit using the enhanced video licence function, we have had reports that the stream connection will flick between connected and network error To resolve this go into the Network ...
Problems with calling function between 2N and Loxone
If the installation is not working as expected when a 2N intercom is integrated to Loxone, and you are confident you have followed all the steps found on the wiki.2n.cz site for the version of miniserver that you are using, then change the sip ...
DTMF code not being received fully from My2N Mobile Video
If you are experiencing a problem with releasing a switch on the 2N intercom and the gate is therefore not releasing, this could be due to the DTMF code not being fully received at the intercom to check - open up the UI of the intercom on your ...
Do you have a template for the 2N Verso or Solo name label?
Yes we do, see attached.
Custom Image On Indoor Touch
Background image – there is the 2N’s launcher enabled in default. If you would like to change or adjust the home screen, you may create your own Android launcher or use some 3rd party launcher. To be able to do that you would need from us an ...
Poor Audio Quality on 2N Verso
The 2N units are 3 high units. When you go 3 high you need to move the microphone down to the bottom.